I know Zilla68 just completed this job so he may have some different advice, which is welcome. Find or Sell any Parts for Your Vehicle in USA. The weld must be cut before attempting to remove the ball joint. NOTE: Some vehicles have the upper ball joint spot-welded to the control arm. Hopefully those who have done this will chime in.**Īfter this job an alignment is probably in order. Purchase SNAP ON BALL JOINT UNIVERSAL BEARING PRESS 14-piece SET CJ91D CJ-91-D in Bethel, Connecticut, US, for US 26.00. The BJP1 ball joint master set is designed to be used without removing the control arm from the vehicle on most cars and trucks that have press-fit type ball joints. **There has been some discussion relating to the torque value of this outer lock nut. Iii) Install the outer lock nut and tighten to 160-205 ft-lbs 24 results for ball joint press snap on Save this search Shipping to: 23917 Shop on eBay Brand New 20. I) Using spanner lock nut wrench while rotating the front disc brake hub and rotor back and forth, tighten the inner lock nut to 50 ft-lbs to seat the bearing. Tighten the nuts that hold the spindle on to 50-60 ft-lbs and the tie rod nut to 70 ft-lbs and install a NEW cotter pin.Ģ0) To properly seat the hub bearings follow this procedure: Covering the vast majority of current domestic SUVs, light trucks and passenger cars, the Snap-on Master Ball Joint/Universal Joint Press Set, No. This ball joint service kit includes a C-frame press along with installation and. I replaced the rolling diaphragm seals on the outer axle shaft, as well as the grease seal on the back of the hub. Everything you need to service ball joints on most 2WD and 4WD vehicles. ![]() Iii) Tighten the upper nut to the next castellation and install a NEW cotter pinġ9) Install the rest of the pieces in the order they were removed. Called 2 dealers, one said 375 the other 595. Its the ball joint on the end of the track bar at the axle. So I got underneath it and had wifey wag the steering wheel and found the problem. Installs and removes ball joints with pre-fitted straight grease fittings. IMPORTANT: Follow this tightening sequence. 973 Reaction score 5 Location Simpsonville, SC Truck has developed a bit of a wander. ![]() 18) Place the steering knuckle back onto the tube yoke and install the camber bushing in its previous orientation Loosely screw on the upper and lower nuts to hold the knuckle in place.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |